Text · page 31 of 130
Read the whole document on one page (all 130 pages, each with its own heading)
operational; look for indications of any fluid leaks; check fluids for proper levels; visually inspect the vehicle for problems, deficiencies and deterioration. Inside of the van should be inspected for cleanliness of seats, floor and windows. The inside of the van should always be kept clean; it leaves a great impression on the passengers when they see the vehicle upkept well. Pre-Start These are some tasks that should be done before the engine starts. Driver Position The driver should position himself so that they are within reach of all the controls and in position for the greatest visibility. Driver comfort should also be considered. If necessary, the seat should be adjusted to put the driver in the optimum position. This is the first pre- ignition step, as mirrors and seat belt adjustment depend on the driver’s position. Drivers should always wear a seat belt; it is New York State law. The seat belt should be adjusted snugly across the hips. It should be fastened only after the mirrors are adjusted, because the other adjustments cannot be made with the seat belt fastened. Mirror Adjustment Mirrors should be adjusted after seat to provide the greatest amount of visibility around the vehicle. Inside mirrors should also be adjusted to give drivers the greatest amount of visibility of the interior of the vehicle and the passenger inside. Outside mirrors should be adjusted so that the driver can see the rear tires at ground level in the bottom of the mirror and the rear bumper near the inside edge. Starting the Engine Correct starting procedures incorporate factors of safety and preventative maintenance. Each vehicle is equipped with an automatic engine and should start to warm the engine before starting daily operations. Racing the engine within the first three minutes after starting causes a great deal of wear and tear on the engine. After starting the engine, during the warmup period the driver should make additional inspections: oil pressure gauge, amp meter and fuel gauge. Next, there should be an operational inspection done of the parking brake, engine and steering operation. Drivers must know and be able to identify trouble indications. Other items to check: • Steering wheel • Accelerator pedal • Footbrake pedal 30 | P a g e – E r i e C o u n t y G o i n g P l a c e s P o l i c y a n d P r o c e d u r e