Text · page 28 of 86
Read the whole document on one page (all 86 pages, each with its own heading)
(1) All signs shall be constructed of permanent, weather-resistant, and durable materials, except for window signs and otherwise in conformance with this article. (2) Where applicable, signs shall be supported by sign structures that are designed to resist wind pressures, dead loads, and lateral loads in accordance with the appropriate provisions of the New York State Building Code. All sign supports shall be reviewed as part of the sign design. (3) All sign lettering shall be permanently affixed to the sign. Manual changeable copy signs shall be enclosed and locked. Electronic changeable copy signs are prohibited which includes television monitors. (4) No permanent sign may be constructed of untreated or unpainted wood, sandblasted metal, or other unfinished material. (5) The sign should serve to define or enhance the architectural elements of the building, not obscure or obliterate them. (6) Sign colors should be limited to 5 colors and compatible with the building facade. (7) Sign graphics should reflect simplicity, neatness and minimum wording. C. Location. All signs shall be so located in accordance with the following standards: (1) Signs shall not be erected within nor project into any public right-of-way, unless otherwise specified within this article. Signs must be located on private property and comply with the dimensional and setback requirements herein. (2) Off-premises signs are prohibited. (3) All signs, unless otherwise noted within this article, are to be set back at least five feet from any property line. D. Visibility at intersections. No sign or any part of a sign exceeding three feet in height, other than a supporting pole or brace no greater than 18 inches in width or diameter, shall be located within the designated clear sight triangle of any intersecting streets. The clear sight triangle shall be defined by the triangle formed by the center lines of the intersecting streets measured 20 feet outward from the point of intersection of said center lines along such center lines (see Figure 3). E. Illumination. All signs shall be illuminated in accordance with the following standards: