Text · page 73 of 94
Read the whole document on one page (all 94 pages, each with its own heading)
(3) Existing hedgerows, stone walls, woodlots, stream corridors, and other significant natural landscape features should be preserved and incorporated into site design to the maximum extent practicable. (4) A minimum of one tree per 20 feet of frontage shall be planted in the required front yard setback area. Additional trees shall be planted throughout the developed area at a ratio of one tree per 30 feet of side yard and rear yard dimensions. Trees along the side and rear lot lines may be evenly spaced or clustered together to break up the monotony of the design. (5) All trees planted shall have a minimum caliper of 2 1/2 inches as measured six inches above the ground. (6) Plastic or other types of artificial plantings or vegetation shall not be permitted. (7) The primary emphasis of the landscape treatment shall be on trees, and efforts shall be made to preserve existing trees. Shrubbery, hedges, grass and other vegetation should be used to complement the use of trees, but shall not be the sole contribution to the landscape treatment. (8) All landscaped areas required or permitted by this section shall be maintained and preserved according to the plan as originally approved or amended by the Planning Board. Flora that dies shall be replaced within the next planting season with plantings of a similar nature. C. Site lighting; General. It is the intent of these standards and provisions to prevent, reduce or eliminate the problems created by improperly designed and installed outdoor lighting. These provisions are intended to eliminate problems of glare, minimize light trespass and help to reduce energy usage and the financial costs of outdoor lighting by establishing standards that limit the area that certain kinds of outdoor lighting fixtures can illuminate and by limiting the total allowable illumination of properties located in the overlay district. The purpose of these standards is to ensure that outdoor lighting does not interfere with the reasonable use and enjoyment of property and to encourage lighting practices that will prevent light pollution by reducing up-light, glare and over lighting. These regulations are also intended to provide for the safe movement of traffic, for satisfactory vision for pedestrians and for the guidance of both vehicles and pedestrians. (1) Lighting design shall not create a nuisance to adjacent residences. (2) Pole-mounted lighting shall not exceed a total height of 15 feet from finished grade to the top of the fixture. (3) Lighting illumination levels shall not exceed six lux / 0.6 footcandles. (4) All external lighting sources shall be designed and shielded to avoid hazardous interference and direct glare onto adjacent streets and properties. (5) The lenses in pole- and wall-mounted lighting shall be recessed to control the adverse impacts of light spillout and glare. (6) A mixture of lamp types on the same site shall be avoided. (7) To provide optimum color rendition, lamps are preferred in the following order: high- pressure sodium, metal halide, low-pressure sodium. Downloaded from https://ecode360.com/HA0055 on 2024-11-14 73