Text · page 291 of 1493
Read the whole document on one page (all 1493 pages, each with its own heading)
BR Inlets Stand in the Bioretention cell itself and look for all the places where water flows in. Often there will be multiple points of inflow to the practice. Problem (Check if Present) Follow-Up Actions Use a flat shovel to remove grit and debris (especially at curb inlets or openings). Parking lots generate fine grit that will accumulate at these spots. Pull out clumps of growing grass or weeds and scoop out the soil or grit that the plants are growing in. Remove any grass clippings, leaves, sticks, and other debris that is collecting at inlets. For pipes and ditches, remove sediment and debris that is partially blocking the pipe or ditch opening where it enters the Bioretention cell. Dispose of all material properly where it will not re-enter the Bioretention cell. Other: Inlets collect grit and debris or grass/weeds. Some water may not be getting into the Bioretention cell. The objective is to have a clear pathway for water to flow into the cell. Kick-Out to Level 2 Inspection: Inlets are blocked to the extent that most of the water does not seem to be entering the Bioretention cell. For small areas of erosion, smooth out the eroded part and apply rock or stone (e.g., river cobble) to prevent further erosion. Usually, filter fabric is placed under the rock or stone. In some cases, reseeding and applying erosion-control matting can be used to prevent further erosion. Some of these materials may be available at a garden center, but it may be best to consult a landscape contractor. Other: Kick-Out to Level 2 Inspection: Erosion is occurring at most of the inlets, Some or all of the inlets are eroding so that and it looks like there is too much water that is concentrating at these rills, gullies, and other erosion is present, or points. The inlet design may have to be modified. there is bare dirt that is washing into the Bioretention cell. Page 3 of 8 Page 291 of 1493