Text · page 82 of 219
Read the whole document on one page (all 219 pages, each with its own heading)
PART 7 General Development Standards 59 OF 148 C. In general, all signs shall be permanently 2. The height of an awning, projecting, mounted and securely anchored. All ground suspended, wall, or window sign shall signs must be sufficiently secured to prevent be determined by measuring the vertical movement from wind. distance between the top part of the sign D. Illumination. face or structure, whichever is highest, to the bottommost edge of the sign face. 1. Sign illumination shall not cause direct light rays to cross any property line. §7-9-7 Signs Requiring a Permit 2. Sign illumination shall not cause an increase Upon issuance of a building permit in accordance in light measured at any property line, with Chapter 75: Building Code Administration, the other than a street line, of more than one following sign types are permitted pursuant to the foot-candle. following standards: §7-9-6 Measurement A. Building Mounted Signs. A. Sign Area. 1. Wall Sign. 1. One-sided sign. The area of a sign shall be a. Wall signs shall not extend beyond the computed by means of the smallest square, above or beyond the ends of a building circle, rectangle, triangle, or geometric or its parapet, or the highest point of the combination thereof that will encompass the roof, whichever is higher. extreme limits of the writing, representation, b. Wall signs shall not project more than 12 graphic, and/or other display, together with inches from the wall face. any material, backdrop, or structure on which it is placed. 2. Awning Sign. a. No sign shall exceed 20% of the area of 2. Two-sided sign. In the case of a two-sided the awning on which it is located. sign, only one side of the sign is considered in determining sign area if the sides of the 3. Projecting Sign. sign are back-to-back or diverge at an angle a. Only one projecting sign is permitted per of 45° or less. No sign shall be permitted to building frontage that has an entrance for have more than two sides. the general public 3. The supporting structure of a sign shall not b. A projecting sign shall not exceed 16 be computed as part of the sign area unless square feet per side. such supporting structure or bracing is made a part of the message with the inclusion of c. Signs that encroach into a public right- any text or graphics. of-way shall require a permit by the appropriate issuing body prior to their B. Sign Height. installation. 1. The height of a freestanding sign shall d. The bottom edge of the sign shall be a be calculated by measuring the vertical minimum height of 8 feet from finished distance between the top part of such sign grade. or its structure, whichever is highest, to the elevation of the ground directly beneath the 4. Window Sign. center of the sign. a. No sign shall exceed 20% of the area of an individual windowpane.