Text · page 1 of 10
This document was a scan. Its text was produced by character recognition and may contain errors; check the original for exact wording.
Solar Energy Systems Chapter 95A 95A-AC: Utility-scale soar energy systems are only permitted in C-1, C-2, and C-3 zoning districts. 95A-5E: Utility-scale solar energy systems and all solar energy systems over 25 kw shall be subject to all provisions of this chapter and permitted only in the approved districts (C-1, C-2, and C-3) zoning districts. These systems shall require a special use permit, site plan approval from the Town Board and a building permit from the Town of Aurora Building Department. 95A-6C(5): The total surface area of a non-utility-scale said solar energy system on a lot situated in an Agriculture (A) and Commercial (Ci, C2, and C3) District shall not exceed 5% of the total square footage of the entire lot. 95A-6C(6): The total surface area of a utility-scale solar energy system on a lot which is greater than two acres situated in Commercial (C1, C2, and C3) District shall not exceed 10% of the total square footage of the entire lot. 95A-8B(2): As regulated for accessory structures in the Commercial (C1, C2, and C3) uses in Chapter 116 of the Town Code. Subdivision of Land and ODA Chapter 99 Add 99-6B: Prior to submittal of an application, a preliminary meeting with the developer, property owner, Town Supervisor, Superintendent of Highways, and Code Enforcement Officer is required to discuss the proposed subdivision. This meeting will review the basic site design concept and advise the developer as to potential problems or concerns and will assist the developer in determining the information required to begin the process. [move all subsequent sections down one] 99-31A(5): Front Yard Setback A. 200 feet from the boundary line parallel to the street right-of-way B. No accessory building/structure shall be erected in the front yard. Zoning Chapter 116 116-4 Building, Height of: The vertical distance measured from the average elevation of the proposed finished grade at the front of the building to the highest point of the roof for flat roofs, to the deck line of mansard roofs and to the mean height between eaves and ridge for gable, shed, hip and gambrel roofs. Delete 116-8.5D(3) Delete 116-8.5E(3)