Southtowns Record

PB Agenda Packet 8.13.2026

Government
Town of West Seneca
Board
Planning Board
Meeting
Aug 13, 2026, 6:00 p.m.
Posted by publisher
Jul 28, 2026
Kind
Agenda packet
Topics
Water, sewer and drainage, Roads and traffic, Housing, Zoning and land use, Parks and recreation, Budget and taxes, Public safety

Original document

Same meeting

Text · page 1030 of 1174

Read the whole document on one page (all 1174 pages, each with its own heading)

PW 4. Pond Outlet

Description: The pond’s outlet enables the ponded water to discharge to downstream drainage systems or stream
channels. The outlet is often at the base of the dam/embankment on the downstream side. Inspection of this point can
help prevent flooding of the pond and upstream drainage systems and prevent pond failure at a weak point of a pond’s
containment system.
Instruction: Examine the outlet of the pipe on the downstream side of the dam/embankment where it empties into a
stream, channel, or drainage system. Consult the table below for possible problems.

  Table 2.10.4 PW Pond Outlet
Problem (Check if Present)  Follow-Up Actions

    If there is a minor blockage, remove the debris or vegetation
  to allow free flow of water.
    Remove any accumulated trash at the outlet.
    Outlet:

    Kick-Out to Level 2 Inspection:
    If the area at the outlet cannot be easily accessed or if the
  blockage is substantial, a Level 2 Inspection is warranted.
    Erosion at and downstream of the outfall should be
  evaluated by a qualified professional.
    Any structural problems, such as broken pipes, structures
  falling into the stream, or holes or tunnels around the outfall
  pipe, should be evaluated by a Level 2 Inspector and will
  require repair by a qualified contractor.
   The pond outlet is clogged with sediment, trash,    The pool of water at the outlet pipe is discolored, has an
  debris, vegetation, or is eroding, caving in, slumping,  odor, or has excessive algae or vegetative growth.
  or falling apart.

2.11. Infiltration
Areas of Infiltration
Key areas to inspect for Infiltration include
the following:
    IN 1. Drainage Area
    IN 2. Inlets
    IN 3. Infiltration Area
    IN 4. Outlets
Note: The category of Infiltration includes:
    Infiltration Trench – Long, narrow
  infiltration practice, usually with small
  gravel at the surface and a reservoir
  of larger gravel or stone beneath
    Infiltration Basin – Larger practice,
  usually covered with grass and  Figure 2.11.1 Key Areas for Level 1 Inspection of Infiltration Practice
  highly permeable soil beneath
    Dry Well – Small pit filled with stone or gravel, or precast concrete chamber surrounded by stone that receives
  and stores runoff to enable it to infiltrate into the underlying ground.

Maintenance Guidance  41

  Page 1030 of 1174