Southtowns Record

Planning Board agenda packet — October 28, 2026

Government
City of Lackawanna
Board
Planning Board
Meeting
Oct 28, 2026
Kind
Agenda packet
Topics
Zoning and land use, Water, sewer and drainage, Energy and data center siting, Roads and traffic, Parks and recreation, Public safety, Budget and taxes, Short-term rentals, Housing

Original document

Same meeting

Text · page 154 of 219

Read the whole document on one page (all 219 pages, each with its own heading)

PART 11 Permit and Site Plan Procedures;Enforcement and Penalties  131 OF 148

l. Roof sheathing.  be confirmed using established
  procedures. Grade beams shall be
  i.  Plywood, or other wood material,
  installed in both directions for all piles
  when used as roof sheathing,
  considered to carry the breakaway
  shall not be less than 15/32 inch in
  wall load. Knee braces are required
  thickness, and shall be of exterior
  for front row piles that support
  sheathing grade or equivalent. All
  breakaway walls.
  attaching devices for sheathing and
  roof coverings shall be galvanized  ii.  Use of breakaway wall strengths
  or be of other suitable corrosion-  in excess of 20 pounds per square
  resistant material.  foot shall not be permitted unless
  a registered professional engineer
  ii.  All corners, gable ends, and roof
  or architect has developed or
  overhangs exceeding six inches shall
  reviewed the structural design
  be reinforced by the application
  and specifications for the building
  of waterproof industrial adhesive
  foundation and breakaway wall
  applied to all bearing surfaces of any
  components, and certifies that:
  plywood sheet used in the sheathing
  1) the breakaway walls will fail
  of such corner, gable end, or roof
  under water loads less than those
  overhang.
  that would occur during the base
  iii. In addition, roofs should be sloped as  flood; and 2) the elevated portion
  steeply as practicable to reduce uplift  of the building and supporting
  pressures, and special care should be  foundation system will not be
  used in securing ridges, hips, valleys,  subject to collapse, displacement,
  eaves, vents, chimneys, and other  or other structural damage due
  points of discontinuity in the roofing  to the effects of wind and water
  surface.  loads acting simultaneously on all
m. Protection of openings. All exterior glass  building components (structural
  panels, windows, and doors shall be  and nonstructural). Water loading
  designed, detailed, and constructed to  values used shall be those associated
  withstand loads due to the design wind  with the base flood. Wind loading
  speed of 75 mph. Connections for these  values shall be those required by the
  elements must be designed to transfer  building code.
  safely the design loads to the supporting  5.  Nonresidential structures (except
  structure. Panel widths of multiple panel  coastal high hazard areas). The following
  sliding glass doors shall not exceed three  standards apply to new and substantially
  feet.  improved commercial, industrial and
n. Breakaway wall design standards.  other nonresidential structures located in
  areas of special flood hazard, in addition
  i.  The breakaway wall shall have a
  to the requirements in Subsections E(1)
  design safe loading resistance of
  (b), Subdivision proposals, and E(1)(c),
  not less than 10 and not more than
  Encroachments, and Subsection E(2),
  20 pounds per square foot, with the
  Standards for all structures.
  criterion that the safety of the overall
  structure at the point of wall failure